A combination rice mill is one of the essential grain equipment for farmers. The function of a combination rice mill is believed to be well-known to many people. The use of it has brought us a lot of convenience in our lives and also made our meals easier. Delicious and time-saving. In daily life, especially in some rice processing plants, it is necessary to use it every day. So, let's learn about the maintenance and upkeep of combined rice mills.
Maintenance and upkeep of the combined rice mill:
1. Appearance cleaning: If there is dust on the appearance of the rice mill, it can only be wiped with a dry cloth, especially the sieve part. If there are mosquitoes and insects on the surface of the touch screen glass, please clean it thoroughly to avoid affecting the touch effect.
2. Internal cleaning: It is recommended to use a vacuum cleaner to clean the inside of the rice mill once a month. If there is too much dust on the bran, it can cause the rice mill motor to malfunction.
3. When the rice mill is shut down, a small amount of lubricating oil is often added to the bearing to make it run faster.
4. Leakage protection switch: Conduct leakage protection operation once a month. Press the leakage protection button, and the main switch will automatically reset, indicating that the protection status is normal.
5. When operating the rice mill, do not let children play nearby to avoid injury.
6. After a certain period of use, if the rice milling knife is not sharp due to wear and tear, it can be turned over and used. If the rice sieve leaks water, it should be replaced with a new one.
7. Check the quality of rice milling at any time. If the quality does not meet the requirements, the oil drain plug can be adjusted or the gap between the rice mill and the rice mill can be adjusted. The method is: if there are many grains of rice, adjust the drainage pad first, and correspondingly reduce the amount of rice produced (if the amount of rice produced is small, there are still more grains, and the gap between the rice knife and the grinder should be reduced in the center); If there is more, it is necessary to increase the yield of rice (or the gap between the rice cutter and the grinding center).
8. If a high temperature of the bearing shell is found, lubricating oil (such as butter) should be added. Large rice mill
Key maintenance parts of the combination rice mill:
1. Lubrication: For bearings with fixed lubrication points, the lubricating oil or grease should be sufficient and clean, and the quality and grade of the lubricating grease should meet the requirements; Clean the bearings and change the oil according to the specified time (usually around 3 months of operation); Check the bearing temperature when the temperature is high. Explain why.
2. Inspection:
(1) The assembly part of the rice milling room should be kept flat and smooth, and the sieve bars and rice knives should be kept flat.
(2) When a large amount of bran appears in the rice, it should be stopped for inspection. You can pull out the rice mill shaft and check whether the grinding wheel is offset from the rice mill spindle, that is, whether the blowing hole of the grinding wheel is aligned with the spindle;
(3) After the sand roller wears out, the gap between the screen and the sand roller increases, and the rice cutter needs to be adjusted for supplementation; When the radius of the grinding wheel is worn to 5-10 millimeters, the grinding wheel should be replaced.